Posts by Dingo

1) Message boards : Number crunching : Invalid rate. (Message 300)
Posted 15 May 2019 by Dingo
Post:
Tasks are still ending in an error and this was my first one 15 May 2019, 6:51:25 UTC https://boinc.nanohub.org/nanoHUB_at_home/result.php?resultid=1972199

Every one since then has errored out.
2) Message boards : Number crunching : Invalid rate. (Message 241)
Posted 28 Mar 2019 by Dingo
Post:
I have stopped crunching this project and have advised my Team of the results I have found.

I ran 320 tasks and got 41 errors, mostly on Linux. It is all the errors that are the problem as all of them ran over an hour before stopping so I waited 41 hours and no credit. My credit is 1849 and I did 320 good tasks so that is 5.778125 credits per hour which is very very low.

Fix the errors and I will come back.
3) Message boards : Number crunching : Invalid rate. (Message 185)
Posted 6 Feb 2019 by Dingo
Post:
Started a few work units today on the same machine it failed on with Exit status 197 (0x000000C5) EXIT_TIME_LIMIT_EXCEEDED and they are finishing and validating.
4) Message boards : Number crunching : Invalid rate. (Message 169)
Posted 18 Jan 2019 by Dingo
Post:
I am thinking that if I crunch a work unit to the end and it runs out of time because of parameter set by the project I should get credit or the work. My machine has put in the time and it could have been doing another project.

I have a few of these on my Linux machines which this is an example:

https://boinc.nanohub.org/nanoHUB_at_home/result.php?resultid=546262




©2019 COPYRIGHT 2017-2018 NCN